Hole Punches and Bases are now sold individually for sizes 1mm-16mm. 20mm Hole punches come with a base.
The die sets to be used on the Kam Press Machine DK93.
We stock the Kam Press also.
Please read carefully so as you can order the correct die set for your needs.
Nylon base's are no different to brass bases as far as usage goes. We are discontinuing the brass bases due to the rising cost of brass.
When pressing the hole in a 5mm or higher you will need to press down very forcefully and we recommend putting a couple of layers of scrap fabric on top of the base so you have something to cut through too. If you just put your item on it you may find that the hole will not cut all the way through. If you have an old cutting mat you can also cut a piece out and use that on top of the base.
We have carefully chosen die sets that will not only help you make the best items but will make it easier too.
Please note that hole punches may arrive with grease on them, this is to ensure that they will fit your kam press easily. To remove excess grease simply wipe off with a damp, not wet, cloth.
Keep the screw well oiled so as it isn't hard to remove from you kam press.
ALL of our hole punches and flat plates we have designed and had custom made for over 4 years now.
1mm hole punch die set (perfect for hand stitching on leather)
2mm Hole punch die set is used for ALL rivets, spring snaps and 18mm magnetic snap rivets and the screw holes in for locks. If you can only buy 2 die sets... this should be one of them!
3mm Hole Punch
4mm Hole punch is perfect for our 4mm eyelets
8mm Hole Punch Die Set (The 2mm hole punch is the one needed for rivets)
10 mm Hole Punch (suited for our 10mm grommet die sets)
12 mm Hole Punch (suited for our 12mm grommet die sets)
16mm (5/8") hole punch for 5/8" inner grommets
20mm Hole Punch
24 set hole punch to use with flat plates for the easy installation of flip locks and twist locks. Comes with its own divider container.
https://www.dreamybaghardware.com.au/collections/all/die-set
